4-141
Troubleshooting
● Possible Cause:
1. Check the harness and connector of the Trya2 (or HCF) Size1/2/3 Sensor.
2. Tray2 (or HCF) Size1/2/3 Sensor is defective.
● Error message : Load tray 2 (or HCF) with [Letter], [Plain] paper
● Troubleshooting method :
● Symptom :
The paper in tray is not proper.
● Code : 12-001
2. Enter the EDC mode. Execute the tray2 (or HCF)
Size1/2/3 Sensor test.
(EDC Mode Î Test Routines Î Copier Engine/DADF
Test Routine Î 102-090 (100, 110) Î Start Î
Operation Check Î Stop)
1. Check if the Harness is defective.
Check if the connector is connected properly.
1
2
3
To Next Page
Loading...
