4-142
Troubleshooting
● Possible Cause:
1. Check the harness and connector of the Tray3 Size1/2/3 Sensor.
2. Tray3 Size1/2/3 Sensor is defective.
● Error message : Load tray 3 with [Letter], [Plain] paper
● Troubleshooting method :
● Symptom :
The paper in tray is not proper.
● Code : 12-002
2. Enter the EDC mode. Execute the tray3 Size1/2/3
Sensor test.
(EDC Mode Î Test Routines Î Copier Engine/DADF
Test Routine Î 102-160 (170, 040) Î Start Î
Operation Check Î Stop)
1. Check if the Harness is defective.
Check if the connector is connected properly.
.
1
2
3
To Next Page
Loading...
