5
Select Internet Protocol Version 4 (TCP/IPv4) from
the Networking tab and click Properties.
Note
■
The LAN device driver may differ depending on
your LAN device model.
■
To add a network component, click Install in the
screen shown in the figure above. You can add
clients, services, and protocols.
6
Configure the IP settings.
When using DHCP, select Obtain an IP address
automatically. To use a static IP address, select
Use the following IP address, and set the IP
address manually.
Note
When not using DHCP, ask your network
administrator for the IP address.
7
When you have completed the settings, click the OK
button.
The network settings have been completed.
To Next Page
