operating _27
03 OPERATING
Installing the VIRTUAL GUARD
You can confine the Robot vacuum to a particular
section by using Fence (virtual wall) mode.
Button operations
1. Lamp operations
- Fence (virtual wall) Mode: The red lamp flashes.
- Off :The lamp is turned off.
2. Turn the Power Button on
- Whenever you press the Power button, Fence (virtual wall)
mode
➝
Power off is selected in this sequence.
❈
The distance of virtual wall is 2.5m at minimum and may
differ depending on surroundings and movement status of
the robot.
Forming a Fence (virtual wall)
VIRTUAL GUARD creates an invisible barrier that the Robot
vacuum cannot cross.
E.g. in front of pots, furniture, the front door, and so on.
1. Turn the Fence (virtual wall) mode on using the Power
button.
- The mode lamp flashes red.
2. Install the VIRTUAL GUARD in front of the area you
want to block access from the Robot vacuum.
- Install the VIRTUAL GUARD so that the distance detection
sensor can form an invisible barrier that the Robot vacuum cannot cross.
Power Button
Main Body
Detection
Sensor
Lamp
Distance
Detection
Sensor
A fence (virtual wall)
is formed.
Distance
Sensor
DJ68-00630D (EN)-00.indd 27 2014. 7. 23. �� 6:14
To Next Page
Loading...
