34_ operating
Manual Cleaning
You can move the Robot vacuum to clean a particular location
directly by using the remote control.
■
Move the Robot vacuum to the location where you want to perform
manual cleaning.
■
You can manually clean using the remote control only.
Remote control button Configuration Sequence
Directional Buttons
(Forwards, Left, Right)
A backwards function is not
supported.
1. Set the mode.
2. Cancel the mode.
• When the Robot vacuum is docked with the Charger
(station), manual cleaning is not supported.
• Each time you press the Turbo button, the Turbo icon on
the display panel is turned on or off sequentially. When the
Turbo icon is turned on, you can start cleaning in Turbo
mode.
• Each time you press the Dust Sensor button, the Dust
Sensor icon on the display panel is turned on or off
sequentially. When the Dust Sensor icon is turned on, you
can start cleaning in Dust Sensor mode.
NOTE
CAUTION
DJ68-00630D (EN)-00.indd 34 2014. 7. 23. �� 6:14
To Next Page
Loading...
