operating _35
03 OPERATING
Timer Reservation
In this mode, you can schedule the Robot vacuum to start a
once-off cleaning run from a particular time.
■
A scheduled cleaning run is only performed when the Robot
vacuum is docked to the Charger (Station).
Remote Control Configuration Sequence
Blinks
Blinks
Decrease
Increase
1. Press the Schedule button.
- The current setting is
displayed and blinks.
Press the
or
button to
set the hour.
❈
Cleaning Mode
- If there is no previous
reservation, the cleaning
mode is set to Auto mode. If
a reservation exists, cleaning
mode is set to the configured
mode.
Blinks
Blinks
Decrease
Increase
2. Press the Schedule button.
- The time increases/decreases
by 5 minutes. Press the
or
button to set the minutes.
Blinks
Blinks
Decrease
Increase
3. Press the Schedule button.
Press the
or
button to
set the cleaning mode.
- You can select either Auto or
Max cleaning mode.
Blinks
Blinks
4. Press the Schedule button.
- The value you set will
blink and the settings are
completed.
- When the settings are
completed, the configured
time and are displayed.
Canceling the Settings
- If you press the Start/Stop button while the cleaner is charging
or you are setting the time, the settings are canceled.
- Please take note that the settings are canceled if the cleaner
is detached from the Charger (Station).
Timeout
- If there is no input for 1 minute while you are setting the time,
the cleaner exits Time Set mode automatically.
DJ68-00630D (EN)-00.indd 35 2014. 7. 23. �� 6:14
To Next Page
Loading...
