•
Address type : Select an address type of the camera.
` Address type can be different dependingon connected product model.
-
Static : Used to provide the IP address of the camera manually.
-
iPOLiS DDNS : This is available only if the camera is registered with the iPOLiS DDNS(www.samsungipolis.
com) server. Provide the registered domain for DDNS ID.
` Ex) http://www.samsungipolis.com/snb5000 ; provide "snb5000" for iPOLiS DDNS
-
MAC (Samsung) : Available if the camera supports the MAC Address-based DDNS.
-
URL : Used for URL address input.
M
` Refer to the user manual of the connected camera and check the DDNS specification that is supported by the camera.
•
IP : Provide the IP address of the camera.
•
Device Port : Provide the device port of the camera.
•
HTTP Port : Provide the HTTP port of the camera.
•
ID : Provide the ID of the camera that you want to register.
•
Password : Enter the password of the camera to be registered.
5. Select <ONVIF> or <RTSP> for the protocol and enter your input for each field appears.
•
Target Service Address / RTSP URL : Enter the camera’s RTSP access address that supports ONVIF or RTSP.
For more information about the RTSP address, refer to the manual of each applicable network camera.
•
ID : Enter the ID for accessing via ONVIF/RTSP protocol.
•
Password : Enter the password for accessing via ONVIF/RTSP protocol.
•
Mode : Select a mode that is supported by the network camera in RTSP connection mode.
-
TCP : The connection type with the network camera will switch to "RTP over TCP".
-
UDP : The connection type with the network camera will switch to "RTP over UDP".
-
HTTP : The connection type with the network camera will switch to "RTP over TCP (HTTP)".
M
` For <ONVIF> or <RTSP> connection, up to 5 cameras of 2M or 3M resolution can be supported.
To Next Page
Loading...
