English _83
● MENU SETUP
To set the DHCP server
1. On the DHCP Server Setup window, click <Setup>.
2. Select <Run> in the <Status> field.
3. Enter the starting IP and end IP in the <IP Range> field.
4. Fill in the <IP Lease Time> field.
5. Click <OK>.
The IP range entered is set as the DHCP server address of the network.
Check IP
You can check the IP and Mac currently used through the DHCP server, and the connected network port.
[MENU]
▼
<Network>
►▼
<DHCP Server> [ENTER]
▲▼◄►
<Check IP>
▲▼◄►
[ENTER]
•
Network : Select the network port to check the information on IP and others.
802.1x
When connecting to a network, you can select whether to use the 802.1x protocol and install a corresponding
certificate.
802.1x is a certificate system for the server and the client. It can guarantee robust performance against hacking
into the Tx/Rx network data, virus or information leaks.
By using this system, you can block access from a client who is not certified and only allow communication to
certified users and thus increase the level of security.
[MENU]
▼
<Network>
►▼
<802.1x> [ENTER]
▲▼◄►
[ENTER]
To Next Page
Loading...
