• EAPOL Version : Select the EAPOL version to be used as protocol.
` Some switch hubs will not operate if you set them to version <2>. Select version <1>.
• ID : Enter the ID provided by the RADIUS server administrator.
` If the entered ID does not match the ID of the client's certificate, it won't be processed properly.
• Password : Enter the password provided by the RADIUS server administrator.
` If the password you entered does not match that of the client's private key, it won't be processed properly.
• Certificates : Search for a device. Click on <Rescan> to search for a device again.
• CA Certificate : Select this only if your public certificate includes the public key.
• Client Certificate : Select if the public certificate includes a client's authentication key.
• Client Private Key : Select it if the public certificate contains the client private key.
M
` For successful implementation of the 802.1x operating environment, the administrator must use the RADIUS server.
In addition, the switch hub connected to the server must be a device that supports 802.1x.
`
If the time setting of the RADIUS server, the switch hub and an NVR device do not match, communication between them can fail.
` If a password is assigned to the client's private key, the server administrator should confirm the ID and password.
The ID and password allow up to 30 characters each. (But it only supports letters, numbers and special characters ("-", "_",
"." 3 types) only.
Accessing non password-protected files is allowed without entering a password.
` The 802.1x protocol adopted by the NVR is EAP-TLS.
` You need to install all three certificates to use 802.1x.
SSL
You can select a security connection system or install public certificates.
[MENU]
▼
<Network>
►▼
<SSL> [ENTER]
▲▼◄►
[ENTER]
• Secured Connection System : You can select a type of security connection system.
-
HTTP (Non-secured connection)
-
HTTPS (Secured connection using unique certificate)
-
HTTPS (Secured connection using public certificate)
• Install Public Certificate : You can scan and register public certificates to be installed.
If you want to use a certificate, you need to install a certificate file along with and an encryption file.
` The <HTTPS (Secured connection using public certificate)> menu can be selected only if there is a registered public
certificate.
M
` If you make a DDNS connection via hub(router), and you use HTTPS, you need to forward to port 443.
To Next Page
Loading...
