4-3-2. Entering Factory Mode
To enter [Service Mode] Press the remote-control keys in this sequence :
If you do not have Factory remote control•
Power OFF MUTE 1 8 2 Power On
If you have Factory remote control•
INFO Factory
Some items are not available without a factory remote.•
Option
Control
Debug
SVC
ADC/WB
Advanced
T-HKPAKUC-XXXX.XX
T-HKPAKUS-XXXX
T-HKPAKUJ-XXXX
tztv-X.X 1-XXXX-X_2015XXXX.X (XXXX)
BT Version : BLUETOOTH-VER-XXXX
E-Manual : X.XXX
Camera Version : X.XX.XX
Mic Version : X.XX.XX
Blaster Version : XXXXXX-XXXXXX-XXXXXX
E-POP Version : X.XX.X
EDID SUCCESS
HDCP SUCCESS
CABLE : AV / COMP / PC / HDMI /
Option : 65A1UU9Y,US,9500,None
DTP Not Support
FRC[XXXX-XXX] Panel[XXX-120HZ]
FW[57XX] DATA[0303] LD[DIRECT-XXXXX][XX]
TCON[HXXXXXXX] Flash[J65XXXXX]
SPL Flash S/N: XXXXXXXXXXXXXXX
Model : UNXXJSXXXX
Wired MAC SUCCESS
Wireless MAC SUCCESS
WIFI Version : ****
CO Nfo WO MO D/ HX P/ AO O S/ N/ RO SC/Six
Factory Data Ver : XXX / EERC Version : XX
CPLD/LD : N/A
SmartControl : ****
Date of purchase : --/--/----
NOTE
We recommend to use a standard IR remote to enter Service Mode as BT remote(Smart Controller) won’t work.
Main SW Version
Sub Version (Main, Jak)
Bluetooth Version
E-Manual Version
Camera Version
IR Blaster Version
To Next Page
Loading...
Need help?
General