If you press the Power button and then press and hold the Spin Only button for 2 seconds, the spin time is displayed
on the display panel.
Then repeat pressing the Spin Only button until the required spin level is selected and press the Start/Pause button.
3-3. Spin Only
3.Instruction of Function
3-4. Garment+
You can add or take out laundry items even after the wash has started, as long as the “Garment+” light is turned on.
Pressing the Start/Pause button unlocks the door, unless the water is too hot or if there is too much water in your
washer. If you are able to unlock the door and wish to continue the wash cycle, close the door and press the
Start/Pause button.
3-5. My cycle(WF210)
Allows you to activate your custom wash(temperature, spin, soil level, etc.) with one-button convenience.
By pushing the My Cycle button, you activate the settings used during the My Cycle mode. The “My Cycle” light will
indicate activation.
You can select all options as follows in the My Cycle mode.
4.Select cycle using the Cycle Selector.
5.After cycle selection, set each option.
6.Then, you can store the cycle and options you select by pressing the Start/Pause button in the My Cycle mode.
The cycle and options you select will be displayed the next time you choose the My Cycle function.
To Next Page
Loading...
