Problem What To Do
Will Not Lock
• Door is not aligned or closed properly.
• Perform Quick Test Mode. Check Door Lock. Check the output voltage of Door
Lock Coil.If it reads 120V, change Door Lock Switch, and if not, change PCB.
(Refer to PCB Connector Check.)
• Read Lock Switch and PCB (CN3). (Refer to PCB Connector Check.)
• Try Door Lock and check for 120V to Door Lock Connector. If 120V present,
change Main Control Board and if not, change Door Lock switch.
5-1. Troubleshooting
5.SVC Information
To Next Page
Loading...
