Samsung WF220ANW/XAA - SVC Information; Troubleshooting

Problem What To Do
Will Not Start
•Plug the unit into the wall outlet. Check for proper voltage.
• Check fuse or reset circuit breaker.
• Push any key to turn on the washer and press the Start/Pause key to run the
washer.
• Close door and push the Start/Pause key to run the washer.
• Check if washer is in a pause, soak or suds process. Wait briefly and it may
start. (If the washer is in suds period, Suds will light up instead of remaining
time.)
• Check for restricted drain system. (If there is electrical problem in drain system,
“nd” error will occur after 15 minutes.)
• Check Water Supply.
• Check the line or water valve screen filter.
• Check if PCB connectors are assembled properly.
• Check if CN2 terminals on PCB are in good condition. (Refer to PCB Connector
Check.)
• Replace PCB.
5-1. Troubleshooting
5.SVC Information