5-6. Q & A
5.Reference Information
Q. How long does it take for the door to
unlock?
A. It takes approximately 2-3 seconds for the door to unlock.
Q. The cycle is complete and “End” is
displayed. How do I set another cycle?
A. When “End” is displayed, the Power button should be
pressed or door should be opened before selecting
another cycle. The display will show “End” until washer is
turned off. To turn off washer, the Power button should be
pressed or the door should be opened
Q. What should I do when Information Code
(“dc”) lights up?
A. When the Information Code is displayed, press the
Start/Pause dial and then restart the cycle. For more
information, refer to the Owner’s Manual
Q. There is a small amount of water left in
Detergent Drawer after the load is
complete. Is this normal?
A. It is normal for a small amount of water remaining in
Detergent Drawer after it completes washing. Bleach is
usually flushed out into the tub at the beginning of the
washing. Also, its compartment is washed again during the
following rinse cycle, removing any remnants.
To Next Page
Loading...
