Problem What To Do
Wrong Water Temperature
• Check if both of the water taps are fully open.
• Make sure the domestic water heater is set to deliver water lower than 120°F
(49°C) hot water at the tap. Also check water heater capacity and recovery rate.
• If the water heater is located far from the washer, screw out the hot water tap
and let its water pass until you get hot water.
• Too Hot/Too Cold: Reduced amount of water is supplied while PCB controls the
influx to regulate the actual temperature of the water in the tub. This may appear
to be significantly hotter/colder than expected.
• Check if the temperature selection is correct.
• Disconnect inlet hoses from the Water Valve and remove any residue in the
inlet screens.
5-1. Troubleshooting
5.SVC Information
To Next Page
Loading...
