Problem What To Do
Leaking
• Make sure inlet hose connections are not leaking. Check for rubber gasket
damage due to over tightening.
• Check standpipe for leak. Wrap a dry rag around the standpipe opening. If rag
becomes wet, leak is fault of home plumbing. Be sure the standpipe is capable of
accepting the flow of water from the washer.
• Make sure end of drain hose is correctly inserted and secured to drain
standpipe.
• Check internal hose connections (fill, drain systems, dispenser hoses &
clamps).
• Check rubber boot. Remove, reposition and reinstall, if necessary.
• Check for possible kinked dispenser to outer tub hose. Hot water pressurization
may force door open.
5-1. Troubleshooting
5.SVC Information
To Next Page
Loading...
