4. Test Mode & Error Check
4-2. Diagnostic Code & Corrective Action
NO
Error
Code
Description
Corrective Action
10 ds
Door is detected as open while it is trying to lock the
door.
Go to “Quick Test Mode” and then do Door
Lock/Unlock Test
11 tE
Abnormal high/low temperature or resistance
(Thermal sensor or PBA resistance).
Go to “ Board Input Test” and check Water
Temperature. Check loose or pinched wires.
Replace PCB or thermistor.
12 3E
MICOM is attempting to drive the motor but is not
getting any response signals from the hall sensor.
Visual check shows motor is not running. (Locked,
Defective Hall Sensor or Overload)
Evaluate wire harness for loose or unhooked
connections. Go to “ Quick Test Mode” and test
Motor.
To Next Page
Loading...
