-19-
Mechanical disassembly flow chart
1-1 Cabinet top removal-1
2-1 Main board removal-1
3-1 Audio, Panel Temp, Rear junction, R/C
rear board removal
4-1 Filter box assy and Fans removal
6-1 Network joint board assy removal
7-1 Power board assy removal
8-1 Rear fans assy removal-1
9-1 Optical unit assy removal-1
1-2 Cabinet top removal-2
1-3 Prism cover remmovel
1-6 Control board removal
7-4 AC filter board removal
7-2 Relay board removal
8-2 Rear fans assy removal-2
9-2 Optical unit assy removal-2
Mechanical disassembly should be made by following procedures chart.
Following steps show the basic procedures, therefore unnecessary step may
be ignored.
Caution:
The parts and screws should be placed exactly the same position as the
original otherwise it may cause loss of performance and product safety.
The wiring method of the leads and ferrite cores should be returned exactly
the same state as the original, otherwise it may cause lose of performance
and product safety.
Screws Expression
(Type Diameter x Length) mm
T type M Type
Mechanical Disassembly
5-1 A/V board assy removal
7-3 Ballast board removal
1-4 Filter cover removal
2-2 Main board removal-2
9-3 Optical unit assy removal-3
9-4 Optical unit assy removal-4
10-1 Lens shift assy removal
11-1 Lens cover assy removal
12-1 Speakers removal
13-1 Fans and thermistor removal
1-5 Lamp cover removal
To Next Page
Loading...
