Sanyo PLC-WTC500L - Relay Lens Adjustment

-49-
Optical Adjustment
1-2. Relay lens adjustment
1
Loosen 1 screw E and 1 screws G.
2 Move the Relay lens so that the color shading appeared on the top/bottom
and left/right of the screen becomes the same width.
1) Insert a slot driver into the slot F and turn it to move the image horizon-
tally as shown in Fig.1-3,
2) Insert a slot driver into the slot H and turn it to move the image vertically
as shown in Fig.1-4.
3 Tighten the screws E and G to fix the relay lens assy.
Cyan/Magenta Magenta/CyanMagenta/Cyan
Cyan/Magenta
Cyan/Magenta
Magenta/Cyan
(Target screen image)
H
F
Fig.1-3 Fig.1-4
E G
(Back view) (Front view)
White