Sanyo PLC-WXU30 - Page 119

37
English
Use of security type "WEP"
1. Use the Point ! buttons to select "WEP" security type.
2. Select “WEP Key index”. Use the Point ! buttons to choose the HEX or ASCII key. The four (#1–#4)
kinds of WEP keys can be configured. Use the Point  buttons to move to the right frame; use the
Point ! buttons to select a WEP key number (#1–#4).
Refer the table below for the usable number of characters at the WEP security option.
WEP option Characters
WEP64(40)bit ASCII
WEP64(40)bit HEX
WEP128(104)bit ASCII
WEP128(104)bt HEX
5 characters
10 characters
13 characters
26 characters
3. Use the Point  buttons to select the Type field of the WEP key number that corresponds to the
one you selected above and press SELECT button. The WEP key entry screen appears. In the WEP key
entry field, all characters are displayed in “=”. Use the Point ! buttons to select a character; use the
Point buttons to select a character position. Enter all the characters displayed with “3”.
When you select HEX at WEP key index and the entry key contains “=”, t h e “ =” symbol is displayed
in red and setting is denied.
4. Use the Point  buttons to select “Set” and press SELECT button to return to the Wireless setting
screen. Select “Set” in the Wireless setting screen to complete the network setting.
WEP configuration screen
Configuring security with the projector