-10-
Maintenance
Follow these steps to replace the lamp.
Turn off the projector and disconnect the AC power
cord. Allow the projector to cool for at least 45
minutes.
Loosen 2 screws of the lamp with a screwdriver and
pull out the lamp upwards vertically by grasping the
handle.
Replace the lamp with a new one and tighten the 2
screws back into position. Make sure that the lamp
is set properly. Replace the lamp cover and tighten
the screw.
Loosen the screw with a screwdriver, slide and open
the lamp cover.
Connect the AC power cord to the projector and turn
on the projector.
Reset the lamp replacement counter.
See "Resetting the Lamp Counter" on the next page .
1
2
3
4
5
6
ORDER REPLACEMENT LAMP
Type No. POA-LMP127
Service Parts No. 610 339 8600
Lamp
Handle
Screw
Lamp Cover
Screw
Screw
Be sure to reset the Lamp replacement counter after the lamp is replaced. When the Lamp replacement counter is
reset, the LAMP REPLACE indicator stops lighting.
Turn the projector on, press the MENU button to
display the On-Screen Menu. Press the Point ◄►
buttons to move the red frame pointer to the Setting
Menu icon.
Press the Point ▲▼ buttons to move the red frame
pointer to the Lamp counter function and then press
the SELECT button. The first dialog box appears
and shows the total accumulated time of the lamp
usage and the reset option. If you select "Reset",
a "Lamp replacement counter Reset?" message
appears. Select [Yes] to continue.
Another confirmation dialog box appears, select
[Yes] to reset the Lamp replacement counter.
✔Note:
• Do not reset the Lamp replacement counter without
implementation of lamp replacement. Be sure to
reset the Lamp replacement counter only after
replacing the lamp.
1
2
3
Sel e ct [Yes] , t hen
another confirmation
box appears.
Select [Yes] again
to reset the lamp
counter.
To reset the lamp counter, move the
pointer to Reset and then press the
SELECT button. “Lamp replacement
counter Reset?” dialog box is displayed.
Resetting the Lamp Counter
To Next Page
Loading...
