Sanyo PLC-XC50 - Maintenance; Replacing the Filter Cartridge

-7-
Maintenance
Turn off the projector, and unplug the AC power cord
from the AC outlet.
First, clean up the dust on the projector and around
the air vents.
Loosen 2 screws of the filter cover with a screwdriver
and open the filter cover.
Put the new one back into the position and rotate
back the handle. Make sure that the filter cartridge is
properly and fully inserted. Close the filter cover and
tighten the 2 screws back into position.
CAUTION
Make sure the filter cartridge is inserted in the pro-
jector. If the filter cartridge is not inserted, the pro-
jector cannot be turned on.
Do not put anything into the air vents. Doing so may
result in malfunction of the projector.
Reset the filter counter and the scroll counter.
Filter cover
Replacing the Filter Cartridge
Rotate the handle of the filter and pull out the filter
cartridge.
Screws
Filter cartridge
RECOMMENDATION
We recommend avoiding dusty/smoky environments
when operating the projector. Usage in these environ-
ments may cause a poor image quality.
When using the projector under dusty or smoky condi-
tions, dust may accumulate on a lens, liquid crystal pan-
els, or optical elements inside the projector. Such condi-
tion may degrade the quality of the projected image.
When the symptoms above are noticed, contact your
authorized dealer or service station for proper cleaning.
ORDER REPLACEMENT FILTER CARTRIDGE
Replacement filter cartridge can be ordered through your
dealer. When ordering, give the following information to
the dealer.
 ●  ModelNo.ofyourprojector
PLC-XC50/PLC-XC55
 ●  ReplacementFilterCartridgeTypeNo.
POA-FIL-063
(ServicePartsNo.6103397665)
Connect the AC power cord to the projector and turn
on the projector.
7
CLOSE
handle
OPEN
1
2
3
4
5
6
handle