Sanyo PLC-XC50 - Mechanical Disassembly

-13-
z Cabinet Top, Lamp Cover, Filter Cover and Lens Cover removal
Mechanical Disassembly
Mechanical disassembly should be made following procedures in numerical or-
der.
Following steps show the basic procedures, therefore unnecessary step may
be ignored.
Caution:
The parts and screws should be placed exactly the same position as the original
otherwise it may cause loss of performance and product safety.
Screws Expression
(Type Diameter x Length) mm
T type M Type
Holder of Front Glass
Fig.1
Cabinet top
A(M3x8)x8
1. Remove 8 screws A (M3X8) to remove the Cabinet Top.
2. Loosen Screw B (M3X7) to remove the Lamp Cover.
3. Loosen 2 Screws B (M3X7) to remove the Filter Cover.
4. Remove the Control Buttons.
5. Remove the Front Glass and the Front Ring.
6. Remove 2 Screws C (T3X6) to remove the Holder of Front Glass. Remove 2 Screws D
(T3X6) to remove the Holder of Lens Shutter.
Control Buttons
A
B(M3x7)x2
B(M3x7)x1
D(T3x6)x2
A
A
A
A
A
A
C(T3x6)x2
Front Ring
Holder of Lens
Shutter
Lamp Cover
Filter Cover
Front Glass
Lens Shutter
C
D
Turn the Front Ring anticlockwise and
remove the Front Glass.