Sanyo PLC-XC50 - Locations and Directions

-23-
Optical Parts Disassembly
5
10
Fig.8
1
6
11
When mounting or assembling the optical parts in the opti-
cal unit, the parts must be mounted in the specified loca-
tion and direction as shown in figure below.
2
3
4
8
12
, Locations and Directions
Rugged surface
is facing this
side.
Point marker is printed
on this side up
Point marker is printed
on this side up
No. Parts Name
1 Integrator lens (IN)
2 Integrator lens (OUT)
3 Prism beam splitter (PBS)
4 Condenser lens (OUT)
5 Dichroic mirror (B)
6 Dichroic mirror (G)
7 Condenser lens (G)
8 Condenser lens (R)
9 Relay Lens (OUT)
10 Mirror (R)
11 Condenser lens (B)
12 Mirror (B)
7
Film attached
side is facing this
side.
10
9
8