9
Part Names and Functions
Part Names and Functions
Rear Terminal
③ MONITOR OUT
This terminal can be used to output the incoming
RGB signal from COMPUTER IN 1 / DVI-I
terminal or COMPUTER IN 2/COMPONENT IN
terminal to the other monitor (p.14).
① CONTROL PORT
When the projector is controlled by a computer,
connect to this jack with serial control cable.
② COMPUTER IN 2 / COMPONENT IN
Connect output signal from a computer, RGB
scart 21-pin video output or component video
output to this terminal. (pp.14,16)
⑧ AUDIO IN
Connect the audio output from video equipment
connected to ⑤ or ⑨ to this jack. (When
the audio output is monaural, connect it to L
(MONO) jack.). (p.15)
⑨ VIDEO IN
Connect the composite video output from video
equipment to VIDEO jack. (p.15)
⑥ AUDIO OUT (VARIABLE)
Connect an external audio amplifier to this jack.
(pp.14 - 16)
This terminal outputs sound from AUDIO IN
terminal (⑦ or ⑧).
⑨
⑧
①
②
④
⑤
⑥
③
⑦
⑤ S-VIDEO IN
Connect the S-VIDEO output signal from video
equipment to this jack (p.15).
④ COMPUTER IN 1 / DVI-I
Connect computer output (Digital/Analog DVI-I
type) to this terminal (p.14).
⑦ COMPUTER1/ COMPUTER2 COMPONENT
AUDIO IN
Connect the audio output (stereo) from a
computer or video equipment connected to ② or
④ to this jack. (pp14, 16)
To Next Page
Loading...
