Video Input
Video Input
To reset the adjusted data, select Reset and press the
SELECT button. The confirmation box appears and then
select [Yes]. All adjustments returns to their previous
figures.
Reset
Press the Point ◄► buttons to obtain better balance of
contrast. (From 0 to 15.)
Gamma
Press the Point ◄ button to soften the image and the Point
► button to sharpen the image. (From 0 to 15.)
Sharpness
To store the adjusted data, select Store and press the
SELECT button. Select a level from Image 1 to 4 with
the Point ▲▼ buttons and press the SELECT button. A
confirmation box appears and then select [Yes].
Stored data can be called up by selecting "Image" in the
Image Level Selection on pages 40-41.
Store
Exit the Image Adjust Menu.
Quit
Note:
Noise reduction and Progressive cannot be selected
when 480p, 575p, 720p, 1035i, or 1080i is selected.
(p.39)
Interlaced video signal can be displayed in a progressive
picture. Select one of the following.
Off
. . . . disabled.
L1
. . . . . Select "L1" for an active picture.
L2
. . . . . Select "L2" for a still picture.
Film
. . . Select "Film" for watching a film. With this
function, the projector reproduces pictures
faithful to the original film quality.
Progressive
Noise reduction
Noise interference on the screen can be reduced. Select
one of the following to get smoother images.
Off
. . . . disabled.
L1
. . . . . lower reduction
L2
. . . . . higher reduction
Image Level Menu
Move the red frame pointer
to an image item to be set
and then press the SELECT
button.
Store item
The confirmation box
appears and then select
[Yes].
To Next Page
Loading...
