Sanyo PLC-XC50 - Computer Input; Input Source Selection; (Analog);Computer 2 )

25
Basic Operation
Computer Input
Choose Computer 1 (Analog) or Computer 2 by pressing
the INPUT button on the top control or choose Computer
1(Analog) by pressing the COMPUTER 1 button on
the remote control or choose computer 2 by pressing
COMPUTER 2 button on the remote control.
Before using these buttons, correct input source should be
selected through Menu operation as described below.
Input Source Selection (RGB: Computer 1 (Analog)/Computer 2 )
Direct Operation
Input Menu
Input Menu
Input Menu icon
Computer
2
Press the MENU button to display the On-Screen
Menu. Press the Point ◄► buttons to move the red
frame pointer to the Input Menu icon.
1
Press the Point ▲▼ buttons to move the red arrow
pointer to either Computer 1 (Analog) or Computer 2,
and then press the SELECT button.
2
When selecting Computer 1 (Analog), RGB input
source will be selected directly.
When selecting Computer 2, the Source Select Menu
appears. Move the pointer to RGB and then press the
SELECT button.
3
Menu Operation
Note:
When the Input Search function is set On1 or On2, the
input signal will be searched automatically. (p.46)
Computer 1 (Analog)
Computer 2
Computer 1 (Digital)
Remote Control
1
2
+
_
COMPUTER 1 button
COMPUTER 2 button
Top Control
INPUT button
COMPUTER 1 button
Video
Computer 1 (Analog)
Computer 1 (Digital)
Mo v e th e p oi n ter ( red
a r r o w ) t o C o m p u t e r
1(Analog) and press the
SELECT button.
Mo v e th e p oi n ter ( red
arrow) to Computer 2 and
press the SELECT button.
Move the pointer (red
arrow) to RGB.