Sanyo PLC-XF1000 - Page 28

-28-
Mechanical Disassembly
5-2 Filter motor ass'y disassembly
1 Pull the filter gear upward off.
2 Remove 2 screws-A (T3x8) and remove the filter motor.
3 Remove 1 screw-B (T3x8) and remove the hall sensor board.
A
A
B
Filter motor
Filter gear
Hall sensor board
6 Shutter ass'y, motor, lens-net and rear RC boards removal
1 Remove 2 screws-A (T3x12) and remove the shutter ass'y upward off.
2 Remove 2 screws-B (T3x8) and remove the motor board.
3 Remove 2 screws-C (T3x8) and remove the lens-net board.
4 Remove the RC rear board upward off.
A
A
B
B
C
C
Shutter ass'y
Rear RC board
Motor board
Lens-net board