Sanyo PLC-XP100L - Ballast Box Disassembly

-24-
Mechanical Disassembly
8 Cabinet front and ballast box removal
1 Remove 4 screws A (T3x8) and take the cabinet front
upward off.
2 Remove 1 screw B (T3x8) and take the RC front board
off.
3 Remove 1 screw C (M4x8) and pull the ballast box
backward and remove it off.
8-1 Ballast box disassembly
1 Remove 2 screws D (M3x6) and take the shield case
top off
2 Remove ballast board from the shield case bottom.
A
A
A
A
B
C
Ballast box
RC front board
Ballast board
D
D
Isolation sheet