-32-
Optical Parts Disassembly
A
Note on LCD Panel/Prism Ass’y Mounting
After replacing or installing the LCD Panel/Prism ass’y,
please make sure to obtain the best focus in both TELE and
WIDE zoom. If the focus adjustment is required, please ad-
just the positioning of LCD Panel/Prism Ass’y following to
the procedure below.
Focus adjustment:
1 Loosen 4 screws A on the LCD Panel/Prism ass’y with 2.0
mm hex driver.
2 Turn the projector on and project the image with WIDE
zoom, and adjust the FOCUS control to obtain the best
focus.
3 Turn the ZOOM control to the TELE position.
4 Insert a flat screw driver into the slot B and move the LCD
Panel/Prism Ass’y backward or forward by turning the
screwdriver left or right to obtain the proper focus. Confirm
the focus at TELE and WIDE zoom.
5 Tighten 4 screws A to fix the LCD Panel/Prism ass’y.
A
B
To Next Page
Loading...
