Sanyo PLC-XP100L - Page 35

-35-
Optical Parts Disassembly
4 Optical base top removal
Before taking this procedure, remove cabinet top, main
board following to the chapter "Mechanical disassembly".
1 Remove 1 screw A (T3x8) on the thermostat, 1 screw B
(T3x8) on the ballast trigger and 4 screws C (T3x8).
2 Unhook 4 hooks D on the optical base top and take the
optical base top upward off.
A
B C
C
C
C
Thermostat
Ballast trigger
D
D