Sanyo plc-xu4001 - Page 37

37
9LGHR,QSXW
Choose &RPSXWHU&RPSRQHQW or
&RPSXWHU5*%6FDUW
by pressing the COMPONENT or
the COMPUTER 1 button on the remote control. Choose +'0, by pressing the HDMI button on the
remote control or you can press the INPUT button on the top control to choose the desired input
source.
Before using these buttons, correct input source should be selected through Menu operation as
described below.
1
,QSXW0HQX
2
8VHWKH3RLQWŸźEXWWRQVWRVHOHFW
Computer 1 and then press the Point Ź
button.
,QSXW6RXUFH6HOHFWLRQ&RPSRQHQW, Scart,+'0,
When the input source is coming
from video equipment connected
to the COMPUTER IN 1/
COMPONENT IN terminal with a
COMPONENT-VGA Cable, select
Component.
Component
When the input source is coming
from video equipment connected
to the COMPUTER IN 1/
COMPONENT IN terminal with
a Scart-VGA Cable, select 5*%
6FDUW.
5*%6FDUW
Press the MENU button to display the
2Q6FUHHQ0HQX8VHWKH3RLQWŸźEXWWRQV
to select ,QSXW and then press the Point Ź
button or the SELECT button.
31RWH
When the Input search function is set to On 1 or On
2, the input signal will be searched automatically
(p.45).
&20387(5EXWWRQ
5HPRWHFRQWURO
3
8VHWKH3RLQWŸźEXWWRQVWRVHOHFW
Component or 5*%6FDUW and then press
the SELECT button.
&RPSXWHU5*%
&RPSXWHU6FDUW
&20321(17EXWWRQ
&RPSXWHU&RPSRQHQW
Direct Operation
Menu Operation
3UHVVWKH3RLQWŸźEXWWRQV
to select Component or
5*%6FDUW.
7RS&RQWURO
+'0,EXWWRQ
+'0,
When video input signal is
connected to the HDMI jack,
select +'0,.
,1387EXWWRQ