Sanyo plc-xu4001 - Page 54

54
Setting
5HPRWHFRQWURO
This projector provides two different remote
control codes: the factory-set initial code (Code 1)
and the secondary code (Code 2). This switching
function prevents remote control interference
when operating several projectors or video
equipment at the same time.
When operating the projector in Code 2, both the
projector and the remote control must be switched
to Code 2.
7RFKDQJHWKHFRGHIRUWKHSURMHFWRU
Select either Code 1 or Code 2 in this Setting
Menu.
7RFKDQJHWKHFRGHIRUWKHUHPRWHFRQWURO
Press and hold both the MENU and IMAGE
buttons together for 5 seconds or more. After
changing the code, make sure the remote control
operates properly.
31RWH
:KHQGLIIHUHQWFRGHVDUHVHWRQWKHSURMHFWRUDQGRQ
the remote control, any operation cannot be made.
In that case, switch the code on the remote control
to fit the code on the projector.
,IWKHEDWWHULHVDUHUHPRYHGIURPWKHUHPRWHFRQWURO
for a long period of time, the remote control code will
be reset.
5HPRWHFRQWURO
This function allows you to change brightness of
the screen.
Lamp control
31RWH
/DPSFRQWUROFDQQRWEHFKDQJHGIRUDZKLOHDIWHUWXUQLQJRQWKHSURMHFWRU/DPSQHHGVVRPHWLPHWRVWDELOL]HDIWHU
the power is turned on. Stored lamp mode will be active after the lamp is stabilized.
,I0RGHKDVEHHQVHOHFWHGDQGWKHSURMHFWLRQODPSH[FHHGVWKHUHFRPPHQGHGWRWDOKRXUVRIXVHWKH
replacement icon will be displayed at the time of power-on. Then the projector will turn off after 3 minutes.

The Lamp replacement icon will not appear when the Display function is set to 2II (p.46), during )UHH]H (p.25), or
1RVKRZ (p.26).
Lamp control
/DPSOLIHFRQWURO
Select the lamp operation when the total lighting
time of a lamp exceeds the recommended total
hours of use.
Mode 1........ The lamp can be turned on even
after exceeding the recommended
total hours of use.
Mode 2.........The lamp can be turned on even
after exceeding the recommended
total hours of use. But the projector
turns off automatically after 3 minutes.
Lamp replacement icon
Lamp control
$XWR.......Brightness according to the input
signal.
Normal...The lamp power output is maximum.
Eco 1......The lamp power output is 70% of
the Normal mode.
Eco 2......The lamp power output is 53% of
the Normal mode.