Sanyo plc-xu4001 User Manual

59
,QSXW6RXUFH,QIRUPDWLRQ'LVSOD\
The Information Menu is used for checking the status of the image signal being projected and the
operation of the projector.
+V\QFIUHT
9V\QFIUHT
Lamp counter
,QIRUPDWLRQ0HQX
The horizontal frequency of the input signal is
displayed in .+], or - - - .+]when no signal.
The vertical frequency of the input signal is
displayed in +], or +]when no signal.
Numbers of Hz doubles when during Interlace.
The cumulative lamp operating time is displayed.
,1)2EXWWRQ
5HPRWHFRQWURO
Press the Point Ÿź buttons to select the
Information. The Information Menu is displayed.
See below for displayed information.
Power management
Screen
6KXWGRZQ, 5HDG\, 2II and 7LPHU are displayed.
The selected Screen size is displayed.
,QSXW
Lamp status
The selected input source is displayed.
The selected lamp mode is displayed.
Language
The selected language is displayed.
.H\ORFN
The selected Key lock icon is displayed.
3,1FRGHORFN
2II or On 1 or On 2 is displayed.
5HPRWHFRQWURO
The selected remote code is displayed.
Direct Operation
Menu Operation
6(5,$/12
The serial number of the projector is displayed.
The serial number is used to service the projector.
,QIRUPDWLRQ
7RWDOSRZHUVDYLQJV
The saved amount of power and the exhausted
CO2 are displayed.
The information menu changes each time you
press the INFO. button on the remote controller
as follows.
page 1/2 J page 2/2 J hide J page 1/2 J

While the information menu is displayed, press
the Point ŻŹ buttons to display the previous or
next page.
6\VWHP
The selected system is displayed.

Sanyo plc-xu4001 Specifications

General

Brand	Sanyo
Model	plc-xu4001
Category	Projector
Language	English