Sanyo PLV-WF10 - Page 9

-9-
Lamp-ballast-1
Panel-ballast
Lamp-ballast-2
A
A
A
A
A
B
B
B
B
B
B
B
B
Black color
White color
Black tube
Figure (a)
K7A3
K7B3
Lamp-ballast-1
Lamp-ballast-2
K7A4
K7B4
Clear tube
Lamp-ballast-1
Lamp-ballast-2
1. Remove 5 screws A and remove
the Panel ballast.
2. Remove the connectors. Remove
8 screws B and remove the 2
Lamp ballast assemblies.
Note :
When you re-connect the connector of
lamp ballast assembly, be careful not to
mistake. Refer to the figure-(a).
Note:
Be careful not to damage
hook.
The cabinet front bottom is fixed by
the hook.
1. Remove 2 screws-A. Push part(a)
and pull the Cabinet-front-bottom
down.
2. Remove 4 screws B and remove
the Cabinet front top.
3. Remove 7 screws C and remove
the Cabinet front.
1.
Panel ballast and Lamp
ballast Assemblies removal.
2.
Cabinet front bottom,
Cabinet front top and
Cabinet front removal.
A
A
B
B
B
B
C
C
C
C
C
C
C
Cabinet front bottom
Cabinet front top
Cabinet front
Hook
Hook
(a)
(a)