EasyManuals Logo

Sanyo PLV-Z2000 Service Manual

Sanyo PLV-Z2000
134 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
Unplug the AC power cord before cleaning.
Gently wipe the projection lens with a cleaning cloth that contains
a small amount of non-abrasive camera lens cleaner, or use a lens
cleaning paper or a commercially available air blower to clean the
lens. Avoid using an excessive amount of cleaner. Abrasive cleaners,
solvents, or other harsh chemicals might scratch the surface of the
lens.
When the projector is not in use, make sure that the automatic slide
shutter is closed.
Cleaning the Projection Lens
Cleaning the Projector Cabinet
Unplug the AC power cord before cleaning.
Gently wipe the projector body with a dry soft cloth. When the
cabinet is heavily soiled, apply a small amount of mild detergent
and finish with a dry soft cloth. Avoid using an excessive amount of
cleaner. Abrasive cleaners, solvents, or other harsh chemicals might
scratch the surface of the cabinet.
When the projector is not in use, put it in an appropriate carrying case
to protect it from dust and scratches.
Be sure to reset the Filter counter after cleaning or replacing the air filter.
Resetting the Filter Counter
Filter counter
Turn the projector on and press the MENU button to display the
On-Screen Menu. Select the Setting Menu with the Point ed
buttons. Press the Point 8 or OK buttons to access the submenu
items.
Select Filter counter and then use the Point 8 button to select
[Reset] and press the OK button. “Filter counter reset?” appears.
Select [Yes] and then press the OK button.
1
2
Another confirmation dialog box appears, and select [Yes] to
reset the Filter counter.
3
Note:
Do not reset the Filter counter without cleaning or replacing the air filter. Be
sure to reset the Filter counter only after cleaning or replacing the air filter.
Select Filter counter and
use the Point 8 button to
select [Reset] and press the
OK button. “Filter counter
reset?” appears.
Select [Yes] and press
the OK button, then
another confirmation
box appears.
Select [Yes] again to reset
the lamp counter.
- 12 -
Maintenance and Cleaning

Other manuals for Sanyo PLV-Z2000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sanyo PLV-Z2000 and is the answer not in the manual?

Sanyo PLV-Z2000 Specifications

General IconGeneral
Vertical scan range50 - 100 Hz
Horizontal scan range15 - 80 kHz
Projection technologyLCD
Contrast ratio (typical)-
FocusManual
Digital zoom2 x
Focal length range22.6 - 45.3 mm
RS-232 ports1
Dimensions (WxDxH)400 x 346 x 146 mm
Power requirements100 - 240V
Connectivity technologyWired
Lamp typeUHP
Lamp power165 W
Light source typeLamp
Full HDYes
Serial interface typeRS-232
Component video (YPbPr/YCbCr) in2
Noise level26 dB
Power consumption (typical)240 W
Weight and Dimensions IconWeight and Dimensions
Weight7300 g

Related product manuals