Slot-F
Slot-F
Slot-E
Screw-A
Screw-B
1. Integrator lens adjustment-1
1. Turn the projector on.
Input the white raster signal (100% of white raster signal).
2. Loosen the 2 screws-A and screw-B
3. Adjust the slot E to make shading appears on the right and left(magenta and cyan) of the
screen as shown in figure.
4. Adjust the slot F to make shading appears on the top and bottom(cyan and magenta) of
the screen as shown in figure.
Note; Slot F is moved in parallel by operating the right and left simultaneously. Otherwise, the
integrator lens rotates.
- 50 -
Optical Adjustments
To Next Page
Loading...
