Sanyo PLV-Z2000 - Input Source Management; Selecting and Managing Input Sources

9-1
Lamp unit removal.
1. Loosen the 2 screws-A and remove the Lamp unit.
2. Remove the screw-B (T3x8) and remove the Main board holder.
A
Lamp unit
B
Main board holder
9-2
Lamp connector removal.
1. Remove the 2 screws(T3X6) and remove the Lamp connector.
Lamp connector
Caution:
When remove the Lamp ballast cable,
be carefull not to damade the cable.
Ballast Cable
- 24 -
Mechanical disassemblies