Sanyo PLV-Z2000 - Technical Specifications Summary

-57-
Equipment NIL
After replacing or repairing the LAMP IRIS, this re-adjust-
ment is needed.
1. Enter the service mode.
2. Select group/item no. "211 - 7", and the data value
changed from “0” to “1” , then automatic iris adjust-
ment will be done after about 30 sec.
3. After this adjustment, change this data value from “
1” to
“0” manually for normal operation.
3. Lamp Iris adjustment
Electrical Adjustments
Input signal 16-step gray scale signal (XGA1)
Input mode PC Analog
Input image Natural
1. Enter the service mode.
2. Select group/item no. "260 - 0", and the data value
changed from “0” to “1” , then automatic adjustment
will be done after about 30 sec.
3. After this adjustment completed, “
OK” will appere on
screen.
4. PC input adjustment
Input signal NTSC colour bar
Input mode (Video)
Input image Natural
1. Enter the service mode.
2. Select group/item no. "260 - 0", and the data value
changed from “0” to “1” , then automatic adjustment
will be done after about 30 sec.
3. After this adjustment completed, “
OK” will appere on
screen.
Note ;
Include the white 100%, black 0% red 100%, bule 100%
and green 100% in the color bar of the input signal.
5. Composite (NTSC) input adjustment
Input signal 480i (Y, Cb, Cr) colour bar
Input mode (Component1)
Input image Natural
1. Enter the service mode.
2. Select group/item no. "260 - 0", and the data value
changed from “0” to “1” , then automatic adjustment
will be done after about 30 sec.
3. After this adjustment completed, “
OK” will appere on
screen.
Note ;
Include the white 100%, black 0% red 100%, bule 100%
and green 100% in the color bar of the input signal.
6. Component (480i) input adjustment
Input signal 480p (Y, Cb, Cr) colour bar
Input mode (Component1)
Input image Natural
1. Enter the service mode.
2. Select group/item no. "260 - 0", and the data value
changed from “0” to “1” , then automatic adjustment
will be done after about 30 sec.
3. After this adjustment completed, “
OK” will appere on
screen.
Note ;
Include the white 100%, black 0% red 100%, bule 100%
and green 100% in the color bar of the input signal.
7. Component (480p) input adjustment
Input signal 720p (Y, Cb, Cr) colour bar
Input mode (Component1)
Input image Natural
1. Enter the service mode.
2. Select group/item no. "260 - 0", and the data value
changed from “0” to “1” , then automatic adjustment
will be done after about 30 sec.
3. After this adjustment completed, “
OK” will appere on
screen.
Note ;
Include the white 100%, black 0% red 100%, bule 100%
and green 100% in the color bar of the input signal.
8. Component (720p) input adjustment