CABL
ANTENNA(CATV)
CONNECTIONS
(Cont'd)
75
ohm
Cable System
TV set
2-way Splitter
'-r--T---.--
r'
(Not supplied)
This cable hookup allows you
either to view
and
record the
same
channel (scrambled or
non-scrambled
signal), or to
view one
channel (non-scram-
bled signal) while
recording
another channel (scrambled or
non-scrambled signal).
CABLE CONVERTER
c::::J
VCR'S
Back
Panel
75
ohm
Coaxial
Cable (supplied)
Note
to
CATV system installer (USA only): This reminder
is
provided to call the
CATV
system installer's attention to Section 820-40 of the NEC which provides guidelines for proper
grounding and,
in
particular, specifies that the cable ground shall
be
connected to the
grounding system
of
the building,
as
close to the point
of
cable entry as practical.
VCR's BACK PANEL
~
fYY"
i
IN
OUT
~
®-®L
f~
~3
Y.~~
ANT
.IN
VHF/UHF
/CATV
·0
VCR
OUTPUT
CHANNEL
SWITCH
During playback of a video tape, and when press TV
NCR
to set
the VCR mode, the
VCR
OUTPUT converter changes the video
and audio
signals to the same type of signals that are used for
TV
broadcasts. Set the
VCR
OUTPUT channel switch (marked
CH3, CH4
and
located
on
the rear panel) to channel 3 or 4.
Select the channel that
is
not used for TV broadcasts
in
your
area.
This
is
your VCR OUTPUT channel.
To
play a tape, or to watch
TV
using
the
VCR's built-in tuner, always set your TV's channel
selector
to the same channel
(3
or 4).
9
To Next Page
Loading...
