SARK 110 - Page 48

SARK
SARKSARK
SARK-
--
-110
110110
110 User’s Manual
Rev 1.2.6 October 3
rd
, 2015 - 48 - © Melchor Varela – EA4FRB 2011-2015
The following parameters should be supplied:
• Sweep:
o None Continuous frequency mode
o Frequency Sweep frequency mode
• Repeat:
o Continuous Continuous signal generation
o Single Signal generator stops after a single sweep
o Count: Signal generator stops when number of sweeps reach count
 <Count>
• Function:
o Linear Linear frequency increase or decrease
o Log Logarithmic frequency increase or decrease
o Bi-Linear Start-Stop-Stop-Start sweep (Linear)
o Bi-Log Start-Stop-Stop-Start sweep (Log)
• Start Frequency:
o <Start> Hertz
• Stop Frequency:
o <Stop> Hertz
• Number of points: Number of steps between start and stop frequency
o <Points>
• Delay uS: Step time
o <Delay uS> Micro-seconds