40
Entering the Place of Adjustment with Subsequent Adjustment (Example)
– Activate the service mode (see page 17).
– Press ) to select weighing platform »WP1«.
– Press the ) key to open the numeric menu. The first menu page is displayed.
– Open menu line 1-20, “Place of adjustment”, by pressing k and ).
Menu item 1-20-1 (latitude) is displayed.
If the geographical latitude and altitude of the place of installation are known,
enter this data under menu items 1-20-1 (latitude) and 1-20-2 (altitude).
If you wish to use the acceleration of gravity at the place of installation for the
basis of adjustment rather than these two parameters, enter this value under
menu item 1-20-3.
Important: A value entered for acceleration of gravity takes precedence over the
combination of geographical latitude and altitude.
display_serv_01201.eps
display_wp1_serv.eps
display_serv_01.eps
To Next Page
Loading...
