Sartorius EVO1S1 - Safety; 2.1 General Safety Instructions; 2.2 Installation Instructions

2.6 Personal Protective Equipment
Personal protective equipment to protect against risks arising
from the material being processed.
t When the workplace or the process in which the device is
used requires personal protective equipment: Wear
personal protective equipment.
2.7 Safety Instructions Concerning Operation
of the Device
− Take care that the glass panel of the operating display is
not damaged (e.g., by falling objects, impact, or extreme
pressure). If the glass panel is damaged, disconnect the
device from the power supply immediately.
− The surface of the operating display should not be touched
with pointed, sharp, hard, or rough objects. You should
only use the touch pen provided or your fingertips. Do not
use parts of clothing (e.g., sleeves) or sponges for cleaning
because these can scratch the surface (e.g., due to rivets or
buttons in the sleeve or sand in the sponge).
− Avoid generating static electricity on theglass panel of
the operating display and plastic casing.
Danger of Damage to the Scale!
Never close a paint can using a hammer while
it is still on the weighing pan.
When closing, place the paint can on a firm,
stable surface.
3 Installation
3.1 Scope of Delivery
Model PMA.
Evolution
PMA.HD
Large weighing pan: d 233 mm
x –
Small weighing pan: d 180 mm
– x
USB cable x x
AC adapter with country-specific
mains adapter
Optional Optional
Installation instructions x x
3.2 Unpacking
Procedure
t Open the packaging, making sure to remove all parts
carefully.
t After unpacking the device, check it immediately for any
external damage.
t If the device is stored temporarily: Store the device
according to the ambient conditions (ambient conditions
see Chapter “7.1 General Data,” page 9).
t Save the box and all parts of the packaging for any future
transport. All cables should be unplugged during trans-
port.
3.3 Selecting a Setup Location
Select the right setup location:
− Set up the device on a stable, even surface that is not
exposed to vibrations.
− Maintain free access to the device at all times.
− The devices must be handled carefully according to the IP
protection rating. The environment must be suitably
secured.
− In the event of use in systems and under ambient condi-
tions with higher safety requirements, you must observe
the requirements and provisions applicable in your
country.
t Choose a location that is not subject to the following
negative influences:
− Heat (heater or direct sunlight)
− Drafts from open windows, AC systems, and doors
− Extreme vibrations during weighing
− Heavy traffic areas (personnel)
− Extremely high humidity
− Electromagnetic fields
− Extremely dry air
Acclimatization
Condensation from humidity can form on the surfaces of a
cold device when it is brought into a warm area. You should
therefore let a device that has been disconnected from its
power source acclimatize for approximately 2hours before
reconnecting it to the supply voltage.
3.4 Installing the Scale
3.4.1 Place the weighing pan on the scale
NOTICE
The device must be disconnected from the power supply for
all assembly work.
t Place the weighing pan onto the
scale from above.
Installation Instructions EVO1S1 | SPO1S1 5
English