Sartorius MIS2 - Configuring the A;D Converter

50
Configuring the A/D Converter
Open the menu access switch
§ Remove the cap that covers the menu access switch on the left-hand side of
the back of the indicator
§ To do this, move the switch to the left (towards the interface connectors).
(„open position“)
– Activate the service mode (see page 48-49)
– Select weighing platform and confirm
– Menu item »
10 2 1«
– Menu item »
10 2 2« to enter
Description of the Equipment
setup
WP-1
)
10 2 2
)
Menuws-li.JPG
S
S
S
o