DQD 507 Rev. 2016-02-18 Page 2
versions or blank; w [up to two numbers and or letters] = type of display unit or blank; d=DAKKS or blank; the
hyphens “-“ may be omitted.
Notes:
1. The external SMPS for use with the above models is considered Equipment Class I, Pollution Degree 2
2. The scale series is to be used with external Switching Power Supply from SINPRO ELECTRONICS CO.
LTD., Model SPU31-106.
3. The above units, when provided with a separate electronic box, can be provided with a Peltier element.
4. The above model is cord connected, Equipment Class I, Pollution Degree 2, Installation category II.
5. Mode of operation: Continuous
6. Environmental Conditions: Normal: 5 to 40 C, 3,000 m max, 80% to temperatures up to 31 ºC decreasing
linearly to 50% rH at 40 ºC; suction pump 2,000m with power supply listed above and 3,000m, if an
alternative Certified/Listed external LPS power supply is certified for use up to 3,000m in minimum.
APPLICABLE REQUIREMENTS
CAN/CSA-C22.2 No. 61010-1-04 - Safety Requirements for Electrical Equipment for Measurement,
Control, and Laboratory Use, Part 1: General Requirements
UL Std. No. 61010-1 (2
nd
Edition) - Safety Requirements for Electrical Equipment for Measurement,
Control, and Laboratory Use - Part 1: General Requirements
MARKINGS
The manufacturer is required to apply the following markings:
x Products shall be marked with the markings specified by the particular product standard.
x Products certified for Canada shall have all Caution and Warning markings in both English and French.
Additional bilingual markings not covered by the product standard(s) may be required by the Authorities Having
Jurisdiction. It is the responsibility of the manufacturer to provide and apply these additional markings, where
Applicable, in accordance with the requirements of those authorities.
The products listed are eligible to bear the CSA Mark shown with adjacent indicators 'C' and 'US' for Canada and
US (indicating that products have been manufactured to the requirements of both Canadian and U.S. Standards) or
with adjacent indicator 'US' for US only or without either indicator for Canada only.
Nameplate adhesive label material approval information:
Self-adhesive label made by Brady (UL file MH17154), type B-438 / Ribbon type R43XX
The products listed are eligible to bear the CSA Mark shown with adjacent indicators 'C' and 'US' for Canada and
US, or with adjacent indicator 'US' for US only, or without either indicator for Canada only.
General: Markings appear as outlined in the Certification Report on an adhesive nameplate, on a screw or rivet
secured metal nameplate or in some other permanent manner. Labels, if shown in the report, may vary slightly in
layout, provided that the required information continues to be shown
To Next Page
Loading...
Need help?
General