Safety Instructions
4 Cubis MSE Operating Instructions
Safety Instructions
This device complies with European Council Directives as well as international regulations and standards for electrical
equipment, electromagnetic compatibility, and the stipulated safety requirements� Improper use or handling can,
however, result in damage and/or injury�
This device should only be operated by trained personnel�
Operators must read these installation instructions, particularly the safety information, and must be familiar with the
operation of the equipment� The operator is required to supplement these safety precautions as appropriate�
The operating personnel must be provided with the appropriate training�
The requirements pertaining to applicable installation regulations must be followed when using electrical equipment
in systems and environmental conditions with increased safety requirements� Relevant laws, standards, regulations,
guidelines and environmental protection laws valid in your country must be observed�
Always keep the equipment and balance freely accessible�
Any installation work or balance operation that does not conform to the instructions will result in forfeiture of all
claims under the manufacturer's warranty�
Danger of Explosion!
1
Do not use this equipment in hazardous areas in which explosive materials are present�
Danger of Electrical Shock!
3
If the device is not used in accordance with the instructions, this can affect the product liability for the device�
2
Make sure that the voltage rating printed on the AC adapter is identical to your local line voltage� The wall outlet must
have a protective grounding conductor� The operating instructions included with the AC adapter must be followed�
2
Do not switch on the equipment if the AC adapter or power cord are damaged� If the balance, the AC adapter or
any of the cables are damaged, disconnect the equipment from the power supply and secure it so that it cannot be
turned on�
2
Chemicals (e�g� gases or liquids) that can corrode and damage the inside or outside of the balance, AC adapter, power cable or
peripherals must be kept away from the equipment�
2
Do not operate the balance unless the housing and the display are undamaged and the housing is closed so that
inadvertent contact with parts inside the equipment is not possible� Make sure that no liquids penetrate the balance
and do not allow conductive parts to touch the balance�
2
Note on Installation:
The operator shall be solely responsible for any modifications to the equipment
and for connecting any cables or equipment not supplied by Sartorius�
Information on operational quality is available upon request from Sartorius�
You should only use peripherals and options supplied by Sartorius�
3
Protection Class of the Balance Housing
– Models with a readability of ≥10 mg and 0�1 mg: These models fulfill the requirements of protection class IP54�
The IP protection only applies to the balance housing and not to the AC adapter�
– The IP protection is only guaranteed when the weighing pan is mounted�
– The IP protection is restricted if the data interfaces are used�
Retain the cover cap for the data output� When the data output is not in use, reapply the cover cap to protect it
against vapors, moisture, and dust or dirt�
To Next Page
Loading...