Cubis MSE Operating Instructions 9
Getting Started
Getting Started
Unpacking the Equipment
t Open the packaging at the top�
t Use both hands to lift the balance, with the packaging, out of the cardboard
box�
t Place the packaging with the balance on the floor�
t Remove the top part of the packaging�
Installation Instructions
t Select the proper setup location:
– Set up the device on a stable, even surface that is not exposed to vibrations
(e�g� weighing stone)�
– Place the device in a location with enough free space around it so that
excessive heat cannot build up�
– Maintain free access to the device at all times�
Choose a location that is not subject to the following negative influences:
– Heat (heater or direct sunlight)
– Drafts from open windows, AC systems and doors
– Extreme vibrations during weighing
– Excessive moisture
Acclimatization
Condensation from humidity can form on the surfaces of a cold device when it is
brought into a substantially warmer area�
To avoid the effects of condensation, condition the balance for about two hours at
room temperature, leaving it unplugged from the power supply�
Carefully read all warnings and safety precautions in the respective section of this
manual�
To Next Page
Loading...
Need help?
General