Care and Maintenance
Cleaning the Weighing Chamber of Balances with a Readability of ≤ 1 µg
t Carefully remove any powdered sample material from beneath the shield disk
using a small car vacuum cleaner with an mini-hose attached�
t Use blotting paper to remove any liquid sample material�
3
Do not insert forceps or similar utensils behind the draft shield plate�
Note: The weighing system is hermetically separated from the area of the draft
shield plate� This prevents spillage or other impurities from entering�
Cleaning the Weighing Pan
All stainless steel parts should be cleaned at regular intervals�
Use a damp cloth or sponge to clean stainless steel parts on the balance�
Only use conventional household cleaning agents which are suitable for stainless
steel (e�g� Stahlfix)� After this, let the device dry�
For additional protection, protective oil may be applied�
Remove the stainless steel weighing pan and thoroughly clean it separately�
Only use solvents for cleaning stainless steel parts�
The stainless steel weighing pan should be cleaned simply by rubbing� After this,
rinse the equipment thoroughly until all residue is removed�
No protective oil should be applied to the stainless steel weighing pan�
78 Cubis MSE Operating Instructions
To Next Page
Loading...
Need help?
General