Satel ETHM-1 Plus - Page 18

16 ETHM-1 Plus SATEL
for the given device). This method allows you to use macro commands defined e.g. for the
INT-TSG keypad in the INTEGRA CONTROL application. Instead of a file with macro
commands defined for the ETHM-1 Plus module, you can load a file with macro commands
defined for the LCD keypad.
The data related to macro commands are stored in the module memory. Before you
start defining the macro commands, click on the “Read” button in the “Macro
commands” tab to read the data from the module. Having defined the macro
commands, click on the “Write” button in the “Macro commands” tab to write the data
to the module. The macro command related data are not read / written when you click
on the button in the main menu of DLOADX program.
Groups
Fig. 10. DLOADX program: “Groups” tab.
The macro commands which are to be available to the mobile device users must be assigned
to one of the four groups. You can assign up to 16 macro commands to the groups. The
DLOADX program presents the macro command groups and the macro commands assigned
to them in the tree form.