SatLab SL600 - Page 60

www.satlabgps.com
60
6. Trouble Shoong
Make sure that both base and rover staons are
set by the same coordinate reference and the
same sengs.
Make sure that SIM pin is disabled and internet
service is available.
Make sure that subscripon is available to
access. To check, free external PC tools like
Ntrip Internet Radio could be used to check
subscripon.
Make sure that the COM port in the computer
has been selected correctly. Baud rate must be
19200 bps 8n1
It is always advisable to use real Serial Ports
on computers. In case of absence, USB-Serial
converters can be used. Make sure that
converter driver has been installed properly.
The total number of satellites being used in
the posion calculaon can vary depending
on the type correcons. If any constellaon
is not included in the correcon stream, total
number of satellites will decrease. Make sure
that correcon format supports and includes all
possible constellaons.
Symptom Possible Reason Soluon
Coordinate system setup
SIM Card
Ntrip Subscripon
Serial Port parameters
USB Serial Coverters
Correcon Type
High error in posion calculaon
Ntrip connecon fails
Cable connecon fails
Low number of satellites